Skip to content

Lesson 6/10 · 15 words · 0 learned

Power electronics and drives

  1. 1

    inverter(noun)

    /in'və:tə/

    a device that changes direct current into alternating current, for example from batteries or solar panels

    The rooftop system uses a 50 kilowatt solar inverter.

    Check the inverter display for any fault codes each morning.

    Synonymsconverterrectifier
  2. 2

    rectifier(noun)

    /'rektifaiə/

    a circuit or device that changes alternating current into direct current

    A bridge rectifier converts the AC supply to DC for the charger.

    One diode in the rectifier had failed, so the DC voltage was low.

    Synonymsconverterinvertertransformer
  3. 3

    power electronics(noun)

    /ˈpaʊər ɪˌlekˈtrɒnɪks/

    the use of semiconductor devices to control and convert electrical power, for example in drives and chargers

    She works as a power electronics engineer designing solar inverters.

    Modern elevators rely on power electronics for smooth speed control.

  4. 4

    converter(noun)

    /kənˈvɜːtə(r)/

    a device that changes electrical power from one form, voltage or frequency to another

    A DC-DC converter supplies 12 volts from the 48 volt battery bank.

    The ship uses a frequency converter to power 60 hertz equipment.

  5. 5

    VFD(abbreviation)

    /ˌviː ef ˈdiː/

    variable frequency drive: a device that controls motor speed by changing the frequency and voltage supplied to it

    Fitting a VFD on the cooling tower fan cut its energy use by forty percent.

    The VFD showed an overcurrent fault when the pump started.

  6. 6

    soft starter(noun)

    /ˈsɒft ˌstɑːtə(r)/

    a device that raises motor voltage gradually during starting to reduce current and mechanical shock

    A soft starter stops the conveyor belt from jerking at start-up.

    Set the soft starter ramp time to ten seconds.

  7. 7

    UPS(abbreviation)

    /ˌjuː piː ˈes/

    uninterruptible power supply: a unit with batteries that keeps equipment running without a break when the mains fails

    The control room equipment is fed from a UPS with thirty minutes of backup.

    Replace the UPS batteries every four to five years.

  8. 8

    thyristor(noun)

    /θaɪˈrɪstə(r)/

    a semiconductor switch that turns on when a signal is applied to its gate and is used to control large currents

    The furnace power is controlled by a thyristor unit.

    A failed thyristor caused one phase of the heater to stay on.

  9. 9

    IGBT(abbreviation)

    /ˌaɪ dʒiː biː ˈtiː/

    insulated-gate bipolar transistor: a fast power switch used in drives, inverters and welding machines

    The drive will not run because an IGBT module is damaged.

    IGBTs switch thousands of times per second inside the inverter.

  10. 10

    MOSFET(abbreviation)

    /ˈmɒsfet/

    metal-oxide-semiconductor field-effect transistor: a transistor widely used as a fast switch in power supplies and electronics

    The switching power supply uses a power MOSFET on the primary side.

    A shorted MOSFET blew the input fuse of the charger.

  11. 11

    SMPS(abbreviation)

    /ˌes em piː ˈes/

    switch-mode power supply: a compact, efficient power supply that switches current on and off at high frequency

    A 24 volt SMPS powers the sensors and PLC in the panel.

    The SMPS is lighter and runs cooler than the old linear supply.

  12. 12

    PWM(abbreviation)

    /ˌpiː dʌbljuː ˈem/

    pulse-width modulation: controlling average power by switching a supply on and off quickly and changing the on time

    The fan speed is controlled with a PWM signal from the controller.

    Raising the PWM frequency reduced the motor noise.

  13. 13

    harmonics(noun)

    /hɑːˈmɒnɪks/

    unwanted currents or voltages at multiples of the supply frequency, often caused by electronic loads

    The many drives in the plant create harmonics that overheat the neutral.

    A harmonic filter was installed to reduce harmonics on the main bus.

  14. 14

    power factor correction(noun)

    /ˈpaʊə ˌfæktə kəˌrekʃn/

    the use of equipment, usually capacitors, to bring the power factor closer to one and reduce wasted current

    The power factor correction panel switches capacitor stages automatically.

    Power factor correction helped the factory avoid penalty charges.

  15. 15

    capacitor bank(noun)

    /kəˈpæsɪtə bæŋk/

    a group of capacitors connected together, mainly used to improve the power factor of an installation

    A 300 kVAr capacitor bank is connected to the main switchboard.

    Two stages of the capacitor bank failed after the voltage surge.