पाठ 5/10 · 17 शब्द · 0 याद हो गए
Electronic components and PCBs
इलेक्ट्रॉनिक घटक और PCB
डायोड
a semiconductor component that allows current to flow in one direction only
Fit a diode across the relay coil to protect the transistor.
ट्रांजिस्टर की सुरक्षा के लिए रिले कॉइल के आर-पार एक डायोड लगाएँ।
Use the diode test function on the multimeter to check it.
समानार्थीrectifiersemiconductor diodeप्रतिरोधक, रेज़िस्टर
a component that limits the current in a circuit by providing a fixed amount of resistance
Read the colour bands to find the value of the resistor.
प्रतिरोधक का मान जानने के लिए रंगीन पट्टियाँ पढ़ें।
Add a resistor in series to limit the current through the LED.
समानार्थीresistanceelectrical resistorविलोमconductorsuperconductorअर्धचालक, सेमीकंडक्टर
a material such as silicon that conducts electricity only under certain conditions, used to make diodes, transistors and chips
Silicon is the most widely used semiconductor in electronics.
सिलिकॉन इलेक्ट्रॉनिक्स में सबसे अधिक उपयोग किया जाने वाला अर्धचालक है।
Heat is the main enemy of semiconductor devices in power equipment.
समानार्थीsolid-state devicemicrochipविलोमconductorinsulatorसोल्डर, टाँका
a soft metal alloy that is melted to join wires and component leads electrically
A cracked solder joint caused the display to flicker.
सोल्डर जोड़ में दरार के कारण डिस्प्ले झिलमिला रहा था।
We switched to lead-free solder to meet export rules.
समानार्थीbrazeweldfusejoinविलोमdisconnectseparatedetachट्रांजिस्टर
a semiconductor component used to switch or amplify electrical signals
The output transistor switches the relay coil on and off.
आउटपुट ट्रांजिस्टर रिले कुंडली को चालू और बंद करता है।
A shorted transistor was found on the driver board.
समानार्थीsemiconductoramplifierelectronic componentविलोमvacuum tuberesistorcapacitorसंधारित्र, कैपेसिटर
a component that stores electrical charge for a short time and releases it, used for filtering and timing
The power supply failed because an electrolytic capacitor had dried out.
बिजली आपूर्ति इसलिए विफल हो गई क्योंकि एक इलेक्ट्रोलाइटिक संधारित्र सूख गया था।
Always discharge large capacitors before touching the circuit board.
समानार्थीcondenserelectrical storage deviceविलोमresistorinductorप्रेरक, इंडक्टर
a coil of wire that stores energy in a magnetic field and resists changes in current
The inductor in the filter blocks high-frequency noise.
फ़िल्टर में लगा इंडक्टर उच्च-आवृत्ति वाले शोर को रोकता है।
A small inductor smooths the output current of the converter.
प्रकाश उत्सर्जक डायोड, LED
light-emitting diode: a semiconductor component that gives out light when current passes through it
The green LED on the module shows that power is on.
मॉड्यूल पर लगी हरी LED दर्शाती है कि बिजली चालू है।
Replacing the old lamps with LED fittings cut lighting costs by half.
समाकलित परिपथ, एकीकृत परिपथ, IC
a small chip containing many electronic components such as transistors and resistors, built as one unit
The timer function is handled by a single integrated circuit.
टाइमर का कार्य एक ही समाकलित परिपथ द्वारा संभाला जाता है।
Handle each integrated circuit carefully to avoid static damage.
वोल्टेज रेगुलेटर, वोल्टता नियामक
a component or circuit that keeps the output voltage steady even when the input or load changes
A 5 volt voltage regulator supplies the logic part of the board.
5 वोल्ट का वोल्टेज रेगुलेटर बोर्ड के लॉजिक भाग को आपूर्ति देता है।
The voltage regulator was very hot because the input voltage was too high.
पोटेंशियोमीटर, परिवर्ती प्रतिरोधक
a variable resistor with a knob or screw used to adjust voltage or settings in a circuit
Turn the potentiometer slowly to adjust the motor speed.
मोटर की गति समायोजित करने के लिए पोटेंशियोमीटर को धीरे-धीरे घुमाएँ।
The sensor sensitivity is set with a small potentiometer on the board.
मुद्रित परिपथ बोर्ड, PCB
printed circuit board: a flat board with copper tracks that holds and connects electronic components
The PCB was cracked near the connector after the unit was dropped.
यूनिट गिरने के बाद PCB कनेक्टर के पास से टूट गया।
Our factory does PCB assembly for several electronics brands.
SMD, सतह-आरोहित घटक
surface-mount device: a small component soldered directly onto the surface of a circuit board, without wire leads through holes
SMD parts are placed on the board by a pick-and-place machine.
SMD पुर्ज़ों को पिक-एंड-प्लेस मशीन द्वारा बोर्ड पर लगाया जाता है।
Replacing an SMD capacitor by hand needs a fine soldering tip.
थ्रू-होल, छिद्र-पार
describing components whose wire leads go through holes in a circuit board and are soldered on the other side
Large connectors are still through-hole parts for extra strength.
अतिरिक्त मज़बूती के लिए बड़े कनेक्टर आज भी थ्रू-होल पुर्ज़े ही रखे जाते हैं।
Through-hole components are easier to replace during field repairs.
सोल्डरिंग आयरन, टाँका यंत्र
a hand tool with a hot metal tip used to melt solder and join components
Set the soldering iron to about 350 degrees for this work.
इस काम के लिए सोल्डरिंग आयरन को लगभग 350 डिग्री पर सेट करें।
Clean the soldering iron tip on a damp sponge between joints.
हीट सिंक, ऊष्मा-अवशोषक
a metal part with fins attached to a component to carry heat away and keep it cool
Apply thermal paste before fixing the transistor to the heat sink.
ट्रांज़िस्टर को हीट सिंक पर कसने से पहले थर्मल पेस्ट लगाएँ।
Dust on the heat sink made the drive shut down from overheating.
