본문으로 건너뛰기

레슨 5/10 · 17단어 · 외운 단어 0

Electronic components and PCBs

전자 부품과 인쇄 회로 기판

  1. 1

    diode(noun)

    /ˈdaɪəʊd/

    다이오드

    a semiconductor component that allows current to flow in one direction only

    Fit a diode across the relay coil to protect the transistor.

    트랜지스터를 보호하려면 릴레이 코일 양단에 다이오드를 설치하십시오.

    Use the diode test function on the multimeter to check it.

    유의어rectifiersemiconductor diode
  2. 2

    resistor(noun)

    /rɪˈzɪstər/

    저항기, 저항

    a component that limits the current in a circuit by providing a fixed amount of resistance

    Read the colour bands to find the value of the resistor.

    컬러 밴드를 읽어 저항기의 값을 확인하세요.

    Add a resistor in series to limit the current through the LED.

    유의어resistanceelectrical resistor
    반의어conductorsuperconductor
  3. 3

    semiconductor(noun)

    /ˈsemikəndʌktər/

    반도체

    a material such as silicon that conducts electricity only under certain conditions, used to make diodes, transistors and chips

    Silicon is the most widely used semiconductor in electronics.

    실리콘은 전자 분야에서 가장 널리 쓰이는 반도체이다.

    Heat is the main enemy of semiconductor devices in power equipment.

    유의어solid-state devicemicrochip
    반의어conductorinsulator
  4. 4

    solder(noun)

    /ˈsɑːdər/

    땜납, 솔더

    a soft metal alloy that is melted to join wires and component leads electrically

    A cracked solder joint caused the display to flicker.

    솔더 접합부에 균열이 생겨 디스플레이가 깜박거렸습니다.

    We switched to lead-free solder to meet export rules.

    유의어brazeweldfusejoin
    반의어disconnectseparatedetach
  5. 5

    transistor(noun)

    /trænˈzɪstər/

    트랜지스터

    a semiconductor component used to switch or amplify electrical signals

    The output transistor switches the relay coil on and off.

    출력 트랜지스터가 릴레이 코일을 켜고 끈다.

    A shorted transistor was found on the driver board.

    유의어semiconductoramplifierelectronic component
    반의어vacuum tuberesistorcapacitor
  6. 6

    capacitor(noun)

    /kəˈpæsɪtər/

    커패시터, 콘덴서

    a component that stores electrical charge for a short time and releases it, used for filtering and timing

    The power supply failed because an electrolytic capacitor had dried out.

    전해 커패시터가 말라 버려서 전원 공급장치가 고장 났습니다.

    Always discharge large capacitors before touching the circuit board.

    유의어condenserelectrical storage device
    반의어resistorinductor
  7. 7

    inductor(noun)

    /ɪnˈdʌktə(r)/

    인덕터, 코일

    a coil of wire that stores energy in a magnetic field and resists changes in current

    The inductor in the filter blocks high-frequency noise.

    필터의 인덕터가 고주파 노이즈를 차단한다.

    A small inductor smooths the output current of the converter.

  8. 8

    LED(abbreviation)

    /ˌel iː ˈdiː/

    LED, 발광 다이오드

    light-emitting diode: a semiconductor component that gives out light when current passes through it

    The green LED on the module shows that power is on.

    모듈의 녹색 LED는 전원이 켜져 있음을 나타낸다.

    Replacing the old lamps with LED fittings cut lighting costs by half.

  9. 9

    integrated circuit(noun)

    /ˌɪntɪɡreɪtɪd ˈsɜːkɪt/

    집적 회로, IC

    a small chip containing many electronic components such as transistors and resistors, built as one unit

    The timer function is handled by a single integrated circuit.

    타이머 기능은 하나의 집적 회로가 처리한다.

    Handle each integrated circuit carefully to avoid static damage.

  10. 10

    voltage regulator(noun)

    /ˈvəʊltɪdʒ ˌreɡjuleɪtə(r)/

    전압 조정기, 전압 레귤레이터

    a component or circuit that keeps the output voltage steady even when the input or load changes

    A 5 volt voltage regulator supplies the logic part of the board.

    5볼트 전압 레귤레이터가 보드의 로직 부분에 전원을 공급한다.

    The voltage regulator was very hot because the input voltage was too high.

  11. 11

    potentiometer(noun)

    /pəˌtenʃiˈɒmɪtə(r)/

    가변 저항기, 포텐쇼미터

    a variable resistor with a knob or screw used to adjust voltage or settings in a circuit

    Turn the potentiometer slowly to adjust the motor speed.

    모터 속도를 조절하려면 가변 저항기를 천천히 돌리십시오.

    The sensor sensitivity is set with a small potentiometer on the board.

  12. 12

    PCB(abbreviation)

    /ˌpiː siː ˈbiː/

    인쇄 회로 기판, PCB

    printed circuit board: a flat board with copper tracks that holds and connects electronic components

    The PCB was cracked near the connector after the unit was dropped.

    제품을 떨어뜨린 후 커넥터 근처의 PCB에 균열이 생겼다.

    Our factory does PCB assembly for several electronics brands.

  13. 13

    trace(noun)

    /treɪs/

    패턴, 배선 패턴, 트레이스

    a thin copper line on a printed circuit board that connects components electrically

    A burnt trace on the board was repaired with a short wire.

    기판에서 타버린 패턴을 짧은 전선으로 수리했다.

    Make the power traces wider so they can carry more current.

  14. 14

    SMD(abbreviation)

    /ˌes em ˈdiː/

    표면 실장 부품, SMD

    surface-mount device: a small component soldered directly onto the surface of a circuit board, without wire leads through holes

    SMD parts are placed on the board by a pick-and-place machine.

    SMD 부품은 픽 앤 플레이스 장비로 기판에 실장된다.

    Replacing an SMD capacitor by hand needs a fine soldering tip.

  15. 15

    through-hole(adjective)

    /ˈθruː həʊl/

    스루홀, 삽입형, 관통형

    describing components whose wire leads go through holes in a circuit board and are soldered on the other side

    Large connectors are still through-hole parts for extra strength.

    대형 커넥터는 강도를 높이기 위해 여전히 스루홀 부품을 사용한다.

    Through-hole components are easier to replace during field repairs.

  16. 16

    soldering iron(noun)

    /ˈsəʊldərɪŋ ˌaɪən/

    납땜 인두, 인두기

    a hand tool with a hot metal tip used to melt solder and join components

    Set the soldering iron to about 350 degrees for this work.

    이 작업에는 인두 온도를 약 350도로 설정하십시오.

    Clean the soldering iron tip on a damp sponge between joints.

  17. 17

    heat sink(noun)

    /ˈhiːt sɪŋk/

    방열판, 히트싱크

    a metal part with fins attached to a component to carry heat away and keep it cool

    Apply thermal paste before fixing the transistor to the heat sink.

    트랜지스터를 방열판에 고정하기 전에 서멀 페이스트를 바르십시오.

    Dust on the heat sink made the drive shut down from overheating.