コンテンツへスキップ

レッスン5/10 · 17語 · 覚えた単語 0

Electronic components and PCBs

電子部品とプリント基板

  1. 1

    diode(noun)

    /ˈdaɪəʊd/

    ダイオード

    a semiconductor component that allows current to flow in one direction only

    Fit a diode across the relay coil to protect the transistor.

    トランジスタを保護するため、リレーコイルに並列にダイオードを取り付けてください。

    Use the diode test function on the multimeter to check it.

    類義語rectifiersemiconductor diode
  2. 2

    resistor(noun)

    /rɪˈzɪstər/

    抵抗器, 抵抗

    a component that limits the current in a circuit by providing a fixed amount of resistance

    Read the colour bands to find the value of the resistor.

    カラーコードを読んで抵抗器の値を調べなさい。

    Add a resistor in series to limit the current through the LED.

    類義語resistanceelectrical resistor
    対義語conductorsuperconductor
  3. 3

    semiconductor(noun)

    /ˈsemikəndʌktər/

    半導体

    a material such as silicon that conducts electricity only under certain conditions, used to make diodes, transistors and chips

    Silicon is the most widely used semiconductor in electronics.

    シリコンは、電子機器で最も広く使われている半導体である。

    Heat is the main enemy of semiconductor devices in power equipment.

    類義語solid-state devicemicrochip
    対義語conductorinsulator
  4. 4

    solder(noun)

    /ˈsɑːdər/

    はんだ

    a soft metal alloy that is melted to join wires and component leads electrically

    A cracked solder joint caused the display to flicker.

    はんだ接合部の亀裂が原因でディスプレイがちらつきました。

    We switched to lead-free solder to meet export rules.

    類義語brazeweldfusejoin
    対義語disconnectseparatedetach
  5. 5

    transistor(noun)

    /trænˈzɪstər/

    トランジスタ

    a semiconductor component used to switch or amplify electrical signals

    The output transistor switches the relay coil on and off.

    出力トランジスタがリレーコイルのオンとオフを切り替える。

    A shorted transistor was found on the driver board.

    類義語semiconductoramplifierelectronic component
    対義語vacuum tuberesistorcapacitor
  6. 6

    capacitor(noun)

    /kəˈpæsɪtər/

    コンデンサ, キャパシタ

    a component that stores electrical charge for a short time and releases it, used for filtering and timing

    The power supply failed because an electrolytic capacitor had dried out.

    電解コンデンサが干上がったため、電源装置が故障しました。

    Always discharge large capacitors before touching the circuit board.

    類義語condenserelectrical storage device
    対義語resistorinductor
  7. 7

    inductor(noun)

    /ɪnˈdʌktə(r)/

    インダクタ, コイル, 誘導子

    a coil of wire that stores energy in a magnetic field and resists changes in current

    The inductor in the filter blocks high-frequency noise.

    フィルタ内のインダクタが高周波ノイズを遮断する。

    A small inductor smooths the output current of the converter.

  8. 8

    LED(abbreviation)

    /ˌel iː ˈdiː/

    LED, 発光ダイオード

    light-emitting diode: a semiconductor component that gives out light when current passes through it

    The green LED on the module shows that power is on.

    モジュールの緑色のLEDは、電源が入っていることを示している。

    Replacing the old lamps with LED fittings cut lighting costs by half.

  9. 9

    integrated circuit(noun)

    /ˌɪntɪɡreɪtɪd ˈsɜːkɪt/

    集積回路, IC

    a small chip containing many electronic components such as transistors and resistors, built as one unit

    The timer function is handled by a single integrated circuit.

    タイマー機能は1個の集積回路で処理されている。

    Handle each integrated circuit carefully to avoid static damage.

  10. 10

    voltage regulator(noun)

    /ˈvəʊltɪdʒ ˌreɡjuleɪtə(r)/

    電圧レギュレータ, 定電圧回路, 安定化電源IC

    a component or circuit that keeps the output voltage steady even when the input or load changes

    A 5 volt voltage regulator supplies the logic part of the board.

    5 Vの電圧レギュレータが基板のロジック部に電力を供給している。

    The voltage regulator was very hot because the input voltage was too high.

  11. 11

    potentiometer(noun)

    /pəˌtenʃiˈɒmɪtə(r)/

    ポテンショメータ, 可変抵抗器

    a variable resistor with a knob or screw used to adjust voltage or settings in a circuit

    Turn the potentiometer slowly to adjust the motor speed.

    モーターの回転数を調整するには、ポテンショメータをゆっくり回してください。

    The sensor sensitivity is set with a small potentiometer on the board.

  12. 12

    PCB(abbreviation)

    /ˌpiː siː ˈbiː/

    プリント基板, PCB, プリント回路基板

    printed circuit board: a flat board with copper tracks that holds and connects electronic components

    The PCB was cracked near the connector after the unit was dropped.

    本体を落としたため、コネクタ付近でプリント基板に亀裂が入った。

    Our factory does PCB assembly for several electronics brands.

  13. 13

    trace(noun)

    /treɪs/

    配線パターン, パターン, 銅箔パターン

    a thin copper line on a printed circuit board that connects components electrically

    A burnt trace on the board was repaired with a short wire.

    基板上の焼損した配線パターンは、短いワイヤで補修された。

    Make the power traces wider so they can carry more current.

  14. 14

    SMD(abbreviation)

    /ˌes em ˈdiː/

    表面実装部品, SMD, チップ部品

    surface-mount device: a small component soldered directly onto the surface of a circuit board, without wire leads through holes

    SMD parts are placed on the board by a pick-and-place machine.

    SMD部品はチップマウンターによって基板に実装される。

    Replacing an SMD capacitor by hand needs a fine soldering tip.

  15. 15

    through-hole(adjective)

    /ˈθruː həʊl/

    スルーホール, リード挿入型

    describing components whose wire leads go through holes in a circuit board and are soldered on the other side

    Large connectors are still through-hole parts for extra strength.

    大型のコネクタは、強度を確保するため今でもスルーホール部品が使われている。

    Through-hole components are easier to replace during field repairs.

  16. 16

    soldering iron(noun)

    /ˈsəʊldərɪŋ ˌaɪən/

    はんだごて

    a hand tool with a hot metal tip used to melt solder and join components

    Set the soldering iron to about 350 degrees for this work.

    この作業では、はんだごてを約350度に設定してください。

    Clean the soldering iron tip on a damp sponge between joints.

  17. 17

    heat sink(noun)

    /ˈhiːt sɪŋk/

    ヒートシンク, 放熱器

    a metal part with fins attached to a component to carry heat away and keep it cool

    Apply thermal paste before fixing the transistor to the heat sink.

    トランジスタをヒートシンクに固定する前に、放熱グリスを塗ってください。

    Dust on the heat sink made the drive shut down from overheating.