Aralin 2/10 · 16 salita · 0 natutunan
Wiring and installation
Wiring at pagkakabit ng kuryente
kable, kable ng kuryente
one or more insulated conductors inside a protective outer cover, used to carry electricity
We need to lay a 95 square millimetre cable from the transformer to the main board.
Kailangan naming maglatag ng 95 square millimetre na kable mula sa transformer hanggang sa main board.
Check the cable for cuts before pulling it through the conduit.
KasingkahuluganwirecordropestrandlineKasalungatwirelesspagwawakas ng kontrata sa trabaho
the ending of an employment contract, by the employer, the employee or both sides
The termination of his contract takes effect at the end of the month.
Magkakabisa sa katapusan ng buwan ang pagwawakas ng kanyang kontrata.
HR must check the legal reasons for termination before sending the letter.
tubo ng kawad, tubong pananggalang ng kable
a metal or plastic pipe that wires are pulled through to protect them
All wiring in the plant room must run in galvanised steel conduit.
Lahat ng kableng nasa plant room ay dapat dumaan sa galvanized na tubo ng kawad.
The electricians fixed the conduit to the ceiling before pulling the wires.
sahod ng kable, estante ng kable
an open metal support, like a long shelf, used to carry and route many cables
The power cables and control cables run on separate cable trays.
Ang mga kable ng kuryente at ang mga kable ng kontrol ay nasa magkahiwalay na sahod ng kable.
Do not overload the cable tray; leave space for future cables.
kanal ng kable, daluyan ng kawad
an enclosed channel with a removable lid, fixed to walls or ceilings to hold cables
Put the lid back on the trunking after adding the new cables.
Ibalik ang takip ng kanal ng kable matapos magdagdag ng mga bagong kable.
Surface trunking was used because the walls could not be chased.
kahon ng dugtungan, kahon ng koneksiyon
a small enclosed box where wires are joined or split into different circuits
All cable joints must be made inside an accessible junction box.
Lahat ng dugtungan ng kable ay dapat gawin sa loob ng madaling maabot na kahon ng dugtungan.
Use a waterproof junction box for the outdoor lighting.
saksakan, outlet ng kuryente
a device fixed to a wall or panel into which a plug is inserted to get power
Each workstation needs two socket outlets near the bench.
Bawat workstation ay nangangailangan ng dalawang saksakan malapit sa mesa.
The socket outlet in the kitchen was scorched by a loose connection.
switch ng ilaw, suwits ng ilaw
a switch on a wall used to turn lights on and off
Mount the light switch 1.2 metres above the finished floor.
Ikabit ang switch ng ilaw sa taas na 1.2 metro mula sa tapos na sahig.
A two-way light switch lets you control the stair lights from both floors.
terminal block, bloke ng terminal
an insulated block with screw or spring clamps used to connect wires securely inside a panel
Land the field wires on the terminal block at the bottom of the panel.
Ikabit ang mga field wire sa terminal block sa ibaba ng panel.
Each terminal block is numbered to match the wiring diagram.
cable gland, panikip ng kable
a fitting that holds and seals a cable where it enters an enclosure or panel
Tighten the cable gland so dust and water cannot enter the motor box.
Higpitan ang cable gland upang hindi makapasok ang alikabok at tubig sa kahon ng motor.
Armoured cables need a cable gland that also earths the armour.
cable lug, lug ng kable
a metal end fitting pressed onto a cable so it can be bolted to a terminal or busbar
Use the correct size cable lug for the 70 square millimetre conductor.
Gamitin ang tamang sukat ng cable lug para sa 70 square millimetre na konduktor.
The cable lug was loose, so the busbar connection overheated.
i-crimp, pisilin ang lug
to join a connector or lug to a wire by squeezing it tightly with a special tool
Crimp the ferrule onto the wire before inserting it into the terminal.
I-crimp ang ferrule sa kawad bago ito ipasok sa terminal.
Badly crimped lugs are a common cause of hot joints.
balatan ang kawad, tanggalin ang insulation
to remove the insulation from the end of a wire so that it can be connected
Strip about ten millimetres of insulation from each wire.
Balatan ang humigit-kumulang sampung millimetro ng insulation sa bawat kawad.
Be careful not to nick the copper when you strip the cable.
cross-sectional area, sukat ng sektsyon ng kawad
the size of a conductor measured across its cut end, in square millimetres, which shows how much current it can carry
The cable's cross-sectional area must suit the load current and the cable length.
Ang cross-sectional area ng kable ay dapat angkop sa load current at haba ng kable.
A 2.5 square millimetre cross-sectional area is typical for socket circuits.
pagbaba ng boltahe, voltage drop
the loss of voltage along a cable or component because of its resistance
On long cable runs, check the voltage drop does not exceed five percent.
Sa mahahabang takbo ng kable, tiyaking hindi lalampas sa limang porsiyento ang pagbaba ng boltahe.
The pump would not start because of a high voltage drop in the feeder.
panlabas na balot ng kable, sheath
the outer protective layer of a cable that covers the insulated cores
The cable sheath was damaged where it rubbed against the steel beam.
Nasira ang balot ng kable kung saan ito kumiskis sa bakal na biga.
Keep the outer sheath inside the gland so no bare cores are visible.

