コンテンツへスキップ

レッスン2/10 · 16語 · 覚えた単語 0

Wiring and installation

配線と電気設備工事

  1. 1

    cable(noun)

    /ˈkeɪbl/

    ケーブル, 電力ケーブル

    one or more insulated conductors inside a protective outer cover, used to carry electricity

    We need to lay a 95 square millimetre cable from the transformer to the main board.

    変圧器から主配電盤まで、95平方ミリメートルのケーブルを敷設する必要がある。

    Check the cable for cuts before pulling it through the conduit.

    類義語wirecordropestrandline
    対義語wireless
  2. 2

    termination(noun)

    /ˌtɜːmɪˈneɪʃn/

    雇用契約の終了, 契約終了, 解約

    the ending of an employment contract, by the employer, the employee or both sides

    The termination of his contract takes effect at the end of the month.

    彼の契約は月末をもって終了します。

    HR must check the legal reasons for termination before sending the letter.

  3. 3

    conduit(noun)

    /ˈkɒndjuɪt/

    電線管, コンジット

    a metal or plastic pipe that wires are pulled through to protect them

    All wiring in the plant room must run in galvanised steel conduit.

    機械室内の配線はすべて、亜鉛めっき鋼製の電線管に通さなければならない。

    The electricians fixed the conduit to the ceiling before pulling the wires.

  4. 4

    cable tray(noun)

    /ˈkeɪbl treɪ/

    ケーブルトレイ, ケーブルラック

    an open metal support, like a long shelf, used to carry and route many cables

    The power cables and control cables run on separate cable trays.

    動力ケーブルと制御ケーブルは、別々のケーブルトレイに敷設されている。

    Do not overload the cable tray; leave space for future cables.

  5. 5

    trunking(noun)

    /ˈtrʌŋkɪŋ/

    配線ダクト, レースウェイ

    an enclosed channel with a removable lid, fixed to walls or ceilings to hold cables

    Put the lid back on the trunking after adding the new cables.

    新しいケーブルを追加したら、配線ダクトのふたを元に戻すこと。

    Surface trunking was used because the walls could not be chased.

  6. 6

    junction box(noun)

    /ˈdʒʌŋkʃn bɒks/

    ジャンクションボックス, 接続箱

    a small enclosed box where wires are joined or split into different circuits

    All cable joints must be made inside an accessible junction box.

    ケーブルの接続はすべて、点検可能なジャンクションボックス内で行わなければならない。

    Use a waterproof junction box for the outdoor lighting.

  7. 7

    socket outlet(noun)

    /ˈsɒkɪt ˌaʊtlet/

    コンセント, 壁付コンセント

    a device fixed to a wall or panel into which a plug is inserted to get power

    Each workstation needs two socket outlets near the bench.

    各作業席には、作業台の近くにコンセントが2口必要です。

    The socket outlet in the kitchen was scorched by a loose connection.

  8. 8

    light switch(noun)

    /ˈlaɪt swɪtʃ/

    照明スイッチ, 壁スイッチ

    a switch on a wall used to turn lights on and off

    Mount the light switch 1.2 metres above the finished floor.

    照明スイッチは仕上げ床面から1.2メートルの高さに取り付けてください。

    A two-way light switch lets you control the stair lights from both floors.

  9. 9

    terminal block(noun)

    /ˈtɜːmɪnl blɒk/

    端子台, ターミナルブロック

    an insulated block with screw or spring clamps used to connect wires securely inside a panel

    Land the field wires on the terminal block at the bottom of the panel.

    現場からの配線は、盤の下部にある端子台に接続してください。

    Each terminal block is numbered to match the wiring diagram.

  10. 10

    cable gland(noun)

    /ˈkeɪbl ɡlænd/

    ケーブルグランド

    a fitting that holds and seals a cable where it enters an enclosure or panel

    Tighten the cable gland so dust and water cannot enter the motor box.

    粉じんや水がモーターボックスに入らないよう、ケーブルグランドをしっかり締めてください。

    Armoured cables need a cable gland that also earths the armour.

  11. 11

    cable lug(noun)

    /ˈkeɪbl lʌɡ/

    圧着端子, ケーブルラグ

    a metal end fitting pressed onto a cable so it can be bolted to a terminal or busbar

    Use the correct size cable lug for the 70 square millimetre conductor.

    70平方ミリメートルの導体には、適切なサイズの圧着端子を使用してください。

    The cable lug was loose, so the busbar connection overheated.

  12. 12

    crimp(verb)

    /krɪmp/

    圧着する, かしめる

    to join a connector or lug to a wire by squeezing it tightly with a special tool

    Crimp the ferrule onto the wire before inserting it into the terminal.

    端子に差し込む前に、フェルールを電線に圧着してください。

    Badly crimped lugs are a common cause of hot joints.

  13. 13

    strip(verb)

    /strɪp/

    被覆を剥く, 皮むきする

    to remove the insulation from the end of a wire so that it can be connected

    Strip about ten millimetres of insulation from each wire.

    各電線から被覆を約10ミリメートル剥いてください。

    Be careful not to nick the copper when you strip the cable.

  14. 14

    cross-sectional area(noun)

    /ˌkrɒs ˌsekʃənl ˈeəriə/

    断面積, 導体断面積

    the size of a conductor measured across its cut end, in square millimetres, which shows how much current it can carry

    The cable's cross-sectional area must suit the load current and the cable length.

    ケーブルの断面積は、負荷電流とケーブルの長さに適したものでなければなりません。

    A 2.5 square millimetre cross-sectional area is typical for socket circuits.

  15. 15

    voltage drop(noun)

    /ˈvəʊltɪdʒ drɒp/

    電圧降下

    the loss of voltage along a cable or component because of its resistance

    On long cable runs, check the voltage drop does not exceed five percent.

    ケーブルの配線が長い場合は、電圧降下が5パーセントを超えないか確認してください。

    The pump would not start because of a high voltage drop in the feeder.

  16. 16

    sheath(noun)

    /ʃiːθ/

    シース, ケーブル外被

    the outer protective layer of a cable that covers the insulated cores

    The cable sheath was damaged where it rubbed against the steel beam.

    ケーブルのシースは、鉄骨の梁にこすれて損傷していました。

    Keep the outer sheath inside the gland so no bare cores are visible.