본문으로 건너뛰기

레슨 2/10 · 16단어 · 외운 단어 0

Wiring and installation

배선과 전기 설치

  1. 1

    cable(noun)

    /ˈkeɪbl/

    전력 케이블, 케이블

    one or more insulated conductors inside a protective outer cover, used to carry electricity

    We need to lay a 95 square millimetre cable from the transformer to the main board.

    변압기에서 주배전반까지 95제곱밀리미터 케이블을 포설해야 합니다.

    Check the cable for cuts before pulling it through the conduit.

    유의어wirecordropestrandline
    반의어wireless
  2. 2

    termination(noun)

    /ˌtɜːmɪˈneɪʃn/

    근로계약 종료, 근로계약 해지

    the ending of an employment contract, by the employer, the employee or both sides

    The termination of his contract takes effect at the end of the month.

    그의 근로계약 종료는 이달 말에 효력이 발생한다.

    HR must check the legal reasons for termination before sending the letter.

  3. 3

    conduit(noun)

    /ˈkɒndjuɪt/

    전선관, conduit 배관

    a metal or plastic pipe that wires are pulled through to protect them

    All wiring in the plant room must run in galvanised steel conduit.

    기계실의 모든 배선은 아연도금 강관 전선관으로 시공해야 한다.

    The electricians fixed the conduit to the ceiling before pulling the wires.

  4. 4

    cable tray(noun)

    /ˈkeɪbl treɪ/

    케이블 트레이

    an open metal support, like a long shelf, used to carry and route many cables

    The power cables and control cables run on separate cable trays.

    전력 케이블과 제어 케이블은 서로 다른 케이블 트레이에 설치된다.

    Do not overload the cable tray; leave space for future cables.

  5. 5

    trunking(noun)

    /ˈtrʌŋkɪŋ/

    트렁킹, 와이어 덕트, 몰딩

    an enclosed channel with a removable lid, fixed to walls or ceilings to hold cables

    Put the lid back on the trunking after adding the new cables.

    새 케이블을 추가한 후에는 트렁킹의 덮개를 다시 닫으십시오.

    Surface trunking was used because the walls could not be chased.

  6. 6

    junction box(noun)

    /ˈdʒʌŋkʃn bɒks/

    접속함, 정션 박스, 분기함

    a small enclosed box where wires are joined or split into different circuits

    All cable joints must be made inside an accessible junction box.

    모든 케이블 접속은 접근이 가능한 접속함 내부에서 이루어져야 한다.

    Use a waterproof junction box for the outdoor lighting.

  7. 7

    socket outlet(noun)

    /ˈsɒkɪt ˌaʊtlet/

    콘센트

    a device fixed to a wall or panel into which a plug is inserted to get power

    Each workstation needs two socket outlets near the bench.

    각 작업 공간마다 작업대 가까이에 콘센트가 두 개씩 필요합니다.

    The socket outlet in the kitchen was scorched by a loose connection.

  8. 8

    light switch(noun)

    /ˈlaɪt swɪtʃ/

    전등 스위치, 조명 스위치

    a switch on a wall used to turn lights on and off

    Mount the light switch 1.2 metres above the finished floor.

    전등 스위치는 마감 바닥면에서 1.2미터 높이에 설치하십시오.

    A two-way light switch lets you control the stair lights from both floors.

  9. 9

    terminal block(noun)

    /ˈtɜːmɪnl blɒk/

    단자대, 터미널 블록

    an insulated block with screw or spring clamps used to connect wires securely inside a panel

    Land the field wires on the terminal block at the bottom of the panel.

    현장 배선을 패널 하단의 단자대에 결선하십시오.

    Each terminal block is numbered to match the wiring diagram.

  10. 10

    cable gland(noun)

    /ˈkeɪbl ɡlænd/

    케이블 글랜드, 케이블 그랜드

    a fitting that holds and seals a cable where it enters an enclosure or panel

    Tighten the cable gland so dust and water cannot enter the motor box.

    모터 박스에 먼지와 물이 들어가지 않도록 케이블 글랜드를 단단히 조이십시오.

    Armoured cables need a cable gland that also earths the armour.

  11. 11

    cable lug(noun)

    /ˈkeɪbl lʌɡ/

    케이블 러그, 압착 단자

    a metal end fitting pressed onto a cable so it can be bolted to a terminal or busbar

    Use the correct size cable lug for the 70 square millimetre conductor.

    70㎟ 도체에는 알맞은 크기의 케이블 러그를 사용하십시오.

    The cable lug was loose, so the busbar connection overheated.

  12. 12

    crimp(verb)

    /krɪmp/

    압착하다, 압착 접속하다

    to join a connector or lug to a wire by squeezing it tightly with a special tool

    Crimp the ferrule onto the wire before inserting it into the terminal.

    전선을 단자에 삽입하기 전에 페룰을 전선에 압착하십시오.

    Badly crimped lugs are a common cause of hot joints.

  13. 13

    strip(verb)

    /strɪp/

    피복을 벗기다, 탈피하다

    to remove the insulation from the end of a wire so that it can be connected

    Strip about ten millimetres of insulation from each wire.

    각 전선의 절연 피복을 약 10밀리미터 벗기십시오.

    Be careful not to nick the copper when you strip the cable.

  14. 14

    cross-sectional area(noun)

    /ˌkrɒs ˌsekʃənl ˈeəriə/

    단면적, 도체 단면적

    the size of a conductor measured across its cut end, in square millimetres, which shows how much current it can carry

    The cable's cross-sectional area must suit the load current and the cable length.

    케이블의 단면적은 부하 전류와 케이블 길이에 적합해야 합니다.

    A 2.5 square millimetre cross-sectional area is typical for socket circuits.

  15. 15

    voltage drop(noun)

    /ˈvəʊltɪdʒ drɒp/

    전압강하

    the loss of voltage along a cable or component because of its resistance

    On long cable runs, check the voltage drop does not exceed five percent.

    케이블 구간이 길 경우 전압강하가 5퍼센트를 넘지 않는지 확인하십시오.

    The pump would not start because of a high voltage drop in the feeder.

  16. 16

    sheath(noun)

    /ʃiːθ/

    시스, 외피

    the outer protective layer of a cable that covers the insulated cores

    The cable sheath was damaged where it rubbed against the steel beam.

    케이블 시스가 철제 빔에 쓸려 손상되었습니다.

    Keep the outer sheath inside the gland so no bare cores are visible.