Skip to content

Lesson 9/10 · 15 words · 0 learned

Hydraulics and pneumatics

  1. 1

    valve(noun)

    /vælv/

    a device that opens, closes or controls the flow of liquid or gas through a pipe

    Close the main valve before you disconnect the hose.

    A sticking valve was stopping the cylinder from moving.

    Synonymsspigotstopcocktapcockregulator
    Antonymsblockageobstructionclosure
  2. 2

    hose(noun)

    /həʊz/

    a flexible tube that carries liquid or air, for example oil in a hydraulic system

    Replace any hydraulic hose that shows cracks or bulges.

    A burst hose sprayed oil across the floor.

    Synonymstubepipeconduit
    Antonymssolidblockage
  3. 3

    hydraulics(noun)

    /haɪˈdrɔːlɪks/

    the use of liquid under pressure, usually oil, to move or power machines

    Hydraulics are used on the press because they produce very high force.

    He took a short course in industrial hydraulics.

    Synonymsfluid powerhydrodynamicswaterpower
    Antonymspneumaticsmechanics
  4. 4

    pneumatics(noun)

    /njuːˈmætɪks/

    the use of compressed air to move or power machines and tools

    Pneumatics are clean and fast, which suits the packaging line.

    The maintenance team needs more training in pneumatics.

  5. 5

    hydraulic cylinder(noun)

    /haɪˌdrɒlɪk ˈsɪlɪndə(r)/

    a device in which oil under pressure pushes a piston and rod to produce straight-line force

    The main hydraulic cylinder lifts the press ram after each stroke.

    Oil on the rod shows that the hydraulic cylinder seals are leaking.

  6. 6

    pump(noun)

    /pʌmp/

    a machine that moves liquid or gas through pipes, or creates pressure in a hydraulic system

    The hydraulic pump delivers 40 litres per minute.

    A noisy pump can be a sign of air in the oil.

  7. 7

    directional control valve(noun)

    /dəˌrekʃənl kənˈtrəʊl vælv/

    a valve that sends fluid to different paths to make an actuator move forward, back or stop

    The directional control valve decides which way the cylinder moves.

    We replaced the directional control valve after the spool jammed.

  8. 8

    pressure relief valve(noun)

    /ˌpreʃə rɪˈliːf vælv/

    a safety valve that opens automatically to release fluid when the pressure gets too high

    The pressure relief valve is set at 160 bar.

    Never adjust the pressure relief valve without approval.

  9. 9

    solenoid valve(noun)

    /ˈsəʊlənɔɪd vælv/

    a valve opened and closed by an electric coil, so it can be controlled automatically

    The PLC switches the solenoid valve to start the air blast.

    The solenoid valve coil burned out and the cylinder stopped.

  10. 10

    actuator(noun)

    /ˈæktʃueɪtə(r)/

    a part such as a cylinder or motor that turns energy into movement to operate a machine

    A pneumatic actuator opens the gate on the hopper.

    Check the actuator stroke after replacing the seals.

  11. 11

    air compressor(noun)

    /ˈeə kəmpresə(r)/

    a machine that squeezes air into a tank under pressure to power pneumatic tools and equipment

    Drain the water from the air compressor tank every day.

    The factory runs two screw air compressors in turn.

  12. 12

    hydraulic fluid(noun)

    /haɪˌdrɒlɪk ˈfluːɪd/

    the special oil used in a hydraulic system to transfer power, lubricate and cool

    Top up the hydraulic fluid to the middle of the sight glass.

    Dirty hydraulic fluid is the main cause of valve failure.

  13. 13

    fitting(noun)

    /ˈfɪtɪŋ/

    a small part used to connect pipes, hoses or tubes to each other or to equipment

    Tighten the fitting a quarter turn if it is weeping oil.

    Push-in fittings make it quick to connect air lines.

  14. 14

    pressure gauge(noun)

    /ˈpreʃə ɡeɪdʒ/

    an instrument with a dial that shows the pressure of a liquid or gas in a system

    The pressure gauge should read 6 bar when the system is running.

    Fit a pressure gauge after the pump to help with fault finding.

  15. 15

    flow rate(noun)

    /ˈfləʊ reɪt/

    the amount of liquid or gas that passes a point in a certain time, such as litres per minute

    The cylinder speed depends on the flow rate from the pump.

    A blocked filter reduced the flow rate to the cooler.