सामग्री पर जाएँ

पाठ 7/10 · 16 शब्द · 0 याद हो गए

Control systems and automation

नियंत्रण प्रणाली और स्वचालन

  1. 1

    sensor(noun)

    /ˈsensər/

    सेंसर, संवेदक

    a device that detects a physical condition such as temperature, pressure or position and sends a signal

    A faulty temperature sensor made the chiller shut down.

    खराब तापमान सेंसर के कारण चिलर बंद हो गया।

    Wire the pressure sensor to the analogue input of the controller.

    समानार्थीdetectortransducermonitorgaugeprobe
    विलोमnone
  2. 2

    contactor(noun)

    /'kɔntæktə/

    कॉन्टैक्टर

    a heavy-duty relay used to switch power circuits, such as motors, on and off

    The contactor pulls in when the start button is pressed.

    स्टार्ट बटन दबाने पर कॉन्टैक्टर खिंच जाता है।

    Worn contactor tips can cause a motor to run on two phases.

    समानार्थीrelayswitchcircuit breaker
    विलोमinsulatoropen circuit
  3. 3

    control panel(noun)

    /kənˈtrəʊl ˈpænl/

    कंट्रोल पैनल, नियंत्रण पैनल

    an enclosure containing the controls, relays, PLC and indicators that operate a machine or process

    Keep the control panel door closed to stop dust getting in.

    धूल को अंदर जाने से रोकने के लिए कंट्रोल पैनल का दरवाज़ा बंद रखें।

    The control panel was built and tested at our workshop before delivery.

    समानार्थीdashboardinterfaceconsolesettingscommand center
    विलोम(in this contextantonyms are not very applicablebut perhaps) chaosdisorderuncontrolled
  4. 4

    solenoid valve(noun)

    /ˈsəʊlənɔɪd vælv/

    सोलेनॉइड वाल्व, विद्युत चुंबकीय वाल्व

    a valve opened and closed by an electric coil, so it can be controlled automatically

    The PLC switches the solenoid valve to start the air blast.

    पीएलसी हवा का झोंका शुरू करने के लिए सोलेनॉइड वाल्व को चालू करता है।

    The solenoid valve coil burned out and the cylinder stopped.

  5. 5

    actuator(noun)

    /ˈæktʃueɪtə(r)/

    एक्चुएटर, प्रवर्तक

    a part such as a cylinder or motor that turns energy into movement to operate a machine

    A pneumatic actuator opens the gate on the hopper.

    न्यूमेटिक एक्चुएटर हॉपर का गेट खोलता है।

    Check the actuator stroke after replacing the seals.

  6. 6

    PLC(abbreviation)

    /ˌpiː el ˈsiː/

    PLC, प्रोग्राम योग्य लॉजिक नियंत्रक

    programmable logic controller: an industrial controller that reads inputs from sensors and switches outputs to run machines

    The PLC stops the conveyor when the photo sensor detects a jam.

    फ़ोटो सेंसर के जाम का पता लगाते ही PLC कन्वेयर को रोक देता है।

    Check the PLC input lights to see which limit switch is active.

  7. 7

    HMI(abbreviation)

    /ˌeɪtʃ em ˈaɪ/

    HMI, मानव-मशीन इंटरफ़ेस

    human-machine interface: a touch screen or panel that lets operators see machine status and change settings

    The operator reset the alarm from the HMI screen.

    ऑपरेटर ने HMI स्क्रीन से अलार्म रीसेट किया।

    Add a page on the HMI to show the motor running hours.

  8. 8

    SCADA(abbreviation)

    /ˈskɑːdə/

    SCADA, पर्यवेक्षी नियंत्रण एवं डेटा अधिग्रहण

    supervisory control and data acquisition: a system that monitors and controls equipment across a whole plant or network from a central room

    The water company monitors all its pumping stations through SCADA.

    जल कंपनी अपने सभी पंपिंग स्टेशनों की निगरानी SCADA के माध्यम से करती है।

    The SCADA system logged the exact time the breaker tripped.

  9. 9

    proximity sensor(noun)

    /prɒkˈsɪməti ˌsensə(r)/

    प्रॉक्सिमिटी सेंसर, निकटता संवेदक

    a sensor that detects a nearby object without touching it, often used to detect metal parts

    An inductive proximity sensor counts the bolts on the conveyor.

    एक इंडक्टिव प्रॉक्सिमिटी सेंसर कन्वेयर पर बोल्टों की गिनती करता है।

    Set the proximity sensor about three millimetres from the target.

  10. 10

    limit switch(noun)

    /ˈlɪmɪt swɪtʃ/

    लिमिट स्विच, सीमा स्विच

    a switch operated by a moving part of a machine, used to detect its end position

    The door stops when it presses the upper limit switch.

    ऊपरी लिमिट स्विच दबते ही दरवाज़ा रुक जाता है।

    Replace the limit switch if the roller arm is bent.

  11. 11

    relay(noun)

    /ˈriːleɪ/

    रिले

    an electrically operated switch in which a small current through a coil switches a separate circuit

    The PLC output drives a relay that switches the alarm horn.

    PLC आउटपुट एक रिले को चलाता है, जो अलार्म हॉर्न को चालू-बंद करता है।

    The relay contacts were burnt, so the heater would not switch off.

  12. 12

    interlock(noun)

    /ˈɪntəlɒk/

    इंटरलॉक, इंटरलॉकिंग व्यवस्था

    a control arrangement that stops a machine or action unless certain safe conditions are met

    The door interlock stops the machine as soon as the guard is opened.

    जैसे ही गार्ड खोला जाता है, दरवाज़े का इंटरलॉक मशीन को रोक देता है।

    Never bypass a safety interlock to keep production running.

  13. 13

    push button(noun)

    /ˈpʊʃ ˌbʌtn/

    पुश बटन, दाब बटन

    a button on a control panel that is pressed to start, stop or reset equipment

    Press the green push button to start the pump.

    पंप चालू करने के लिए हरा पुश बटन दबाएँ।

    The stop push button has a normally closed contact.

  14. 14

    pilot light(noun)

    /ˈpaɪlət laɪt/

    पायलट लैंप, संकेतक लैंप

    a small indicator lamp on a panel that shows whether equipment is running, stopped or in fault

    The red pilot light shows that the motor has tripped.

    लाल पायलट लैंप दिखाता है कि मोटर ट्रिप हो गई है।

    Replace the pilot light bulb if it does not come on during the lamp test.

  15. 15

    setpoint(noun)

    /ˈsetpɔɪnt/

    सेटपॉइंट, निर्धारित मान

    the target value, such as a temperature or pressure, that a control system tries to maintain

    Raise the pressure setpoint to 5 bar on the controller.

    कंट्रोलर पर दाब का सेटपॉइंट 5 bar तक बढ़ाएँ।

    The room stayed warm because the setpoint was entered wrongly.

  16. 16

    encoder(noun)

    /ɪnˈkəʊdə(r)/

    एनकोडर, घूर्णी एनकोडर

    a sensor fixed to a shaft that sends pulses showing its position, speed or direction

    The encoder on the motor shaft gives speed feedback to the drive.

    मोटर शाफ़्ट पर लगा एनकोडर ड्राइव को गति का फ़ीडबैक देता है।

    A loose encoder cable caused the axis to lose its position.