コンテンツへスキップ

レッスン7/10 · 16語 · 覚えた単語 0

Control systems and automation

制御システムと自動化

  1. 1

    sensor(noun)

    /ˈsensər/

    センサー, 検出器, 感知器

    a device that detects a physical condition such as temperature, pressure or position and sends a signal

    A faulty temperature sensor made the chiller shut down.

    温度センサーの故障により、チラーが停止した。

    Wire the pressure sensor to the analogue input of the controller.

    類義語detectortransducermonitorgaugeprobe
    対義語none
  2. 2

    contactor(noun)

    /'kɔntæktə/

    電磁接触器, コンタクタ

    a heavy-duty relay used to switch power circuits, such as motors, on and off

    The contactor pulls in when the start button is pressed.

    始動ボタンを押すと、電磁接触器が投入されます。

    Worn contactor tips can cause a motor to run on two phases.

    類義語relayswitchcircuit breaker
    対義語insulatoropen circuit
  3. 3

    control panel(noun)

    /kənˈtrəʊl ˈpænl/

    制御盤, 操作盤

    an enclosure containing the controls, relays, PLC and indicators that operate a machine or process

    Keep the control panel door closed to stop dust getting in.

    ほこりが入らないよう、制御盤の扉は閉めておいてください。

    The control panel was built and tested at our workshop before delivery.

    類義語dashboardinterfaceconsolesettingscommand center
    対義語(in this contextantonyms are not very applicablebut perhaps) chaosdisorderuncontrolled
  4. 4

    solenoid valve(noun)

    /ˈsəʊlənɔɪd vælv/

    電磁弁, ソレノイドバルブ

    a valve opened and closed by an electric coil, so it can be controlled automatically

    The PLC switches the solenoid valve to start the air blast.

    PLCが電磁弁を切り替えてエアブローを開始する。

    The solenoid valve coil burned out and the cylinder stopped.

  5. 5

    actuator(noun)

    /ˈæktʃueɪtə(r)/

    アクチュエータ, 作動装置

    a part such as a cylinder or motor that turns energy into movement to operate a machine

    A pneumatic actuator opens the gate on the hopper.

    空気圧アクチュエータがホッパーのゲートを開く。

    Check the actuator stroke after replacing the seals.

  6. 6

    PLC(abbreviation)

    /ˌpiː el ˈsiː/

    プログラマブルロジックコントローラ, PLC, シーケンサ

    programmable logic controller: an industrial controller that reads inputs from sensors and switches outputs to run machines

    The PLC stops the conveyor when the photo sensor detects a jam.

    PLCは、光電センサーが詰まりを検知するとコンベヤを停止させる。

    Check the PLC input lights to see which limit switch is active.

  7. 7

    HMI(abbreviation)

    /ˌeɪtʃ em ˈaɪ/

    ヒューマンマシンインターフェース, HMI, タッチパネル

    human-machine interface: a touch screen or panel that lets operators see machine status and change settings

    The operator reset the alarm from the HMI screen.

    オペレーターはHMI画面からアラームをリセットした。

    Add a page on the HMI to show the motor running hours.

  8. 8

    SCADA(abbreviation)

    /ˈskɑːdə/

    SCADA, 監視制御システム, データ収集監視制御システム

    supervisory control and data acquisition: a system that monitors and controls equipment across a whole plant or network from a central room

    The water company monitors all its pumping stations through SCADA.

    その水道会社は、SCADAを通じてすべての揚水場を監視している。

    The SCADA system logged the exact time the breaker tripped.

  9. 9

    proximity sensor(noun)

    /prɒkˈsɪməti ˌsensə(r)/

    近接センサ, 近接スイッチ

    a sensor that detects a nearby object without touching it, often used to detect metal parts

    An inductive proximity sensor counts the bolts on the conveyor.

    誘導形近接センサがコンベヤ上のボルトの数を数えている。

    Set the proximity sensor about three millimetres from the target.

  10. 10

    limit switch(noun)

    /ˈlɪmɪt swɪtʃ/

    リミットスイッチ, 限時スイッチ

    a switch operated by a moving part of a machine, used to detect its end position

    The door stops when it presses the upper limit switch.

    ドアは上限のリミットスイッチを押すと停止する。

    Replace the limit switch if the roller arm is bent.

  11. 11

    relay(noun)

    /ˈriːleɪ/

    リレー, 継電器

    an electrically operated switch in which a small current through a coil switches a separate circuit

    The PLC output drives a relay that switches the alarm horn.

    PLCの出力がリレーを駆動し、警報ブザーを切り替える。

    The relay contacts were burnt, so the heater would not switch off.

  12. 12

    interlock(noun)

    /ˈɪntəlɒk/

    インターロック, 安全連動装置

    a control arrangement that stops a machine or action unless certain safe conditions are met

    The door interlock stops the machine as soon as the guard is opened.

    ドアのインターロックは、ガードが開けられた瞬間に機械を停止させる。

    Never bypass a safety interlock to keep production running.

  13. 13

    push button(noun)

    /ˈpʊʃ ˌbʌtn/

    押しボタンスイッチ, 押釦スイッチ

    a button on a control panel that is pressed to start, stop or reset equipment

    Press the green push button to start the pump.

    ポンプを起動するには、緑の押しボタンスイッチを押してください。

    The stop push button has a normally closed contact.

  14. 14

    pilot light(noun)

    /ˈpaɪlət laɪt/

    表示灯, パイロットランプ

    a small indicator lamp on a panel that shows whether equipment is running, stopped or in fault

    The red pilot light shows that the motor has tripped.

    赤い表示灯は、モーターがトリップしたことを示している。

    Replace the pilot light bulb if it does not come on during the lamp test.

  15. 15

    setpoint(noun)

    /ˈsetpɔɪnt/

    設定値, 目標値, セットポイント

    the target value, such as a temperature or pressure, that a control system tries to maintain

    Raise the pressure setpoint to 5 bar on the controller.

    コントローラで圧力の設定値を5barに上げてください。

    The room stayed warm because the setpoint was entered wrongly.

  16. 16

    encoder(noun)

    /ɪnˈkəʊdə(r)/

    エンコーダ, ロータリエンコーダ

    a sensor fixed to a shaft that sends pulses showing its position, speed or direction

    The encoder on the motor shaft gives speed feedback to the drive.

    モーター軸のエンコーダが、ドライブに速度フィードバックを送っている。

    A loose encoder cable caused the axis to lose its position.