본문으로 건너뛰기

레슨 7/10 · 16단어 · 외운 단어 0

Control systems and automation

제어 시스템과 자동화

  1. 1

    sensor(noun)

    /ˈsensər/

    센서, 감지기

    a device that detects a physical condition such as temperature, pressure or position and sends a signal

    A faulty temperature sensor made the chiller shut down.

    온도 센서 고장으로 냉각기가 정지했다.

    Wire the pressure sensor to the analogue input of the controller.

    유의어detectortransducermonitorgaugeprobe
    반의어none
  2. 2

    contactor(noun)

    /'kɔntæktə/

    전자접촉기, 마그네트 콘택터

    a heavy-duty relay used to switch power circuits, such as motors, on and off

    The contactor pulls in when the start button is pressed.

    시작 버튼을 누르면 전자접촉기가 투입됩니다.

    Worn contactor tips can cause a motor to run on two phases.

    유의어relayswitchcircuit breaker
    반의어insulatoropen circuit
  3. 3

    control panel(noun)

    /kənˈtrəʊl ˈpænl/

    제어반, 제어판넬

    an enclosure containing the controls, relays, PLC and indicators that operate a machine or process

    Keep the control panel door closed to stop dust getting in.

    먼지가 들어가지 않도록 제어반 문을 닫아 두십시오.

    The control panel was built and tested at our workshop before delivery.

    유의어dashboardinterfaceconsolesettingscommand center
    반의어(in this contextantonyms are not very applicablebut perhaps) chaosdisorderuncontrolled
  4. 4

    solenoid valve(noun)

    /ˈsəʊlənɔɪd vælv/

    솔레노이드 밸브, 전자 밸브

    a valve opened and closed by an electric coil, so it can be controlled automatically

    The PLC switches the solenoid valve to start the air blast.

    PLC가 솔레노이드 밸브를 전환하여 에어 블로우를 시작한다.

    The solenoid valve coil burned out and the cylinder stopped.

  5. 5

    actuator(noun)

    /ˈæktʃueɪtə(r)/

    액추에이터, 작동기

    a part such as a cylinder or motor that turns energy into movement to operate a machine

    A pneumatic actuator opens the gate on the hopper.

    공압 액추에이터가 호퍼의 게이트를 연다.

    Check the actuator stroke after replacing the seals.

  6. 6

    PLC(abbreviation)

    /ˌpiː el ˈsiː/

    PLC, 프로그래머블 로직 컨트롤러

    programmable logic controller: an industrial controller that reads inputs from sensors and switches outputs to run machines

    The PLC stops the conveyor when the photo sensor detects a jam.

    광센서가 걸림을 감지하면 PLC가 컨베이어를 정지시킨다.

    Check the PLC input lights to see which limit switch is active.

  7. 7

    HMI(abbreviation)

    /ˌeɪtʃ em ˈaɪ/

    HMI, 인간-기계 인터페이스, 터치 패널

    human-machine interface: a touch screen or panel that lets operators see machine status and change settings

    The operator reset the alarm from the HMI screen.

    작업자가 HMI 화면에서 경보를 리셋했다.

    Add a page on the HMI to show the motor running hours.

  8. 8

    SCADA(abbreviation)

    /ˈskɑːdə/

    SCADA, 감시 제어 및 데이터 수집 시스템

    supervisory control and data acquisition: a system that monitors and controls equipment across a whole plant or network from a central room

    The water company monitors all its pumping stations through SCADA.

    상수도 회사는 SCADA를 통해 모든 펌프장을 감시한다.

    The SCADA system logged the exact time the breaker tripped.

  9. 9

    proximity sensor(noun)

    /prɒkˈsɪməti ˌsensə(r)/

    근접센서, 근접 스위치

    a sensor that detects a nearby object without touching it, often used to detect metal parts

    An inductive proximity sensor counts the bolts on the conveyor.

    유도형 근접센서가 컨베이어 위의 볼트 수를 센다.

    Set the proximity sensor about three millimetres from the target.

  10. 10

    limit switch(noun)

    /ˈlɪmɪt swɪtʃ/

    리밋 스위치, 한계 스위치

    a switch operated by a moving part of a machine, used to detect its end position

    The door stops when it presses the upper limit switch.

    문이 상한 리밋 스위치를 누르면 멈춘다.

    Replace the limit switch if the roller arm is bent.

  11. 11

    relay(noun)

    /ˈriːleɪ/

    릴레이

    an electrically operated switch in which a small current through a coil switches a separate circuit

    The PLC output drives a relay that switches the alarm horn.

    PLC 출력이 경보 혼을 개폐하는 릴레이를 구동한다.

    The relay contacts were burnt, so the heater would not switch off.

  12. 12

    interlock(noun)

    /ˈɪntəlɒk/

    인터록, 연동 장치

    a control arrangement that stops a machine or action unless certain safe conditions are met

    The door interlock stops the machine as soon as the guard is opened.

    도어 인터록은 가드가 열리는 즉시 기계를 정지시킨다.

    Never bypass a safety interlock to keep production running.

  13. 13

    push button(noun)

    /ˈpʊʃ ˌbʌtn/

    푸시버튼, 누름 버튼

    a button on a control panel that is pressed to start, stop or reset equipment

    Press the green push button to start the pump.

    펌프를 시동하려면 녹색 푸시버튼을 누르십시오.

    The stop push button has a normally closed contact.

  14. 14

    pilot light(noun)

    /ˈpaɪlət laɪt/

    파일럿 램프, 표시등

    a small indicator lamp on a panel that shows whether equipment is running, stopped or in fault

    The red pilot light shows that the motor has tripped.

    빨간색 파일럿 램프는 모터가 트립되었음을 나타낸다.

    Replace the pilot light bulb if it does not come on during the lamp test.

  15. 15

    setpoint(noun)

    /ˈsetpɔɪnt/

    설정값, 목표값

    the target value, such as a temperature or pressure, that a control system tries to maintain

    Raise the pressure setpoint to 5 bar on the controller.

    컨트롤러에서 압력 설정값을 5 bar로 높이십시오.

    The room stayed warm because the setpoint was entered wrongly.

  16. 16

    encoder(noun)

    /ɪnˈkəʊdə(r)/

    엔코더

    a sensor fixed to a shaft that sends pulses showing its position, speed or direction

    The encoder on the motor shaft gives speed feedback to the drive.

    모터 축의 엔코더가 드라이브에 속도 피드백을 제공한다.

    A loose encoder cable caused the axis to lose its position.